The Butt Fender is the original saddle guard.
This clever rear mudguard is lightweight, discreet and requires no fasteners!
It's no secret that plastic is used in most of our products, and this is simply because it's the best material for the job.
As a responsible manufacturer we are committed to sustainability; to produce and sell our products with minimal waste, minimal packaging and we recycle everything we can along the way. Each product is designed to serve it's purpose over many years and is by no means a single use plastic. When a Mucky Nutz product does eventually reach the end of it's functional life, it can be fully recycled and we encourage customers to do so!
Product Code: MN0028Colour: BlackEAN: 5060325480098
Length: 330mmWidth: 134mmMass: 30g
Design Protection: -
We are currently working on updating the fitting instructions across all of our products.
In the meantime please follow the steps below. If you need assistance please get in touch!
Butt Fender fitting instructions:
1. Lightly squeeze the fender along the crease lines to form it into shape. Make sure it stays wider than the tyre width!
2. Slot the 'wings' through the back of the saddle rails, then reach in and pull the hanger downwards to clip onto the bottom rails. It should look like this...
3. Square the shape up and you're good to go!